Version

Revision 1

Used in

• EV One (6521….) / (6522….) / (6531….)

Parts needed

• AC-RCDA-4P40A

Tools needed

• Allen 2.5
• PH2 screwdriver
• Small flat screwdriver

Charger Overview

Replacement instructions

1. Remove the 2 screws at the bottom of the housing. [Allen 2.5]

   

2. Remove the 2 screws holding the door. Place the door in a safe location and remove the housing tube. [Allen 2.5]

   

3. Disconnect the (N / L1 / L2 & L3) cables on top of the RCD (going to the MID). [PH2 screwdriver]

   

4. A hook at the bottom of the RCD is locking the device onto the DIN rail. Pull the hook downwards and remove the RCD. [Small flat screwdriver]

   

5. Position the replacement RCD and connect the cables at the top in the following order from left to right: (Grey - Black - Brown - Blue). [PH2 screwdriver - Torque 2.5 N.m]

   

6. Put the RCD back into position on the DIN rail. Secure it by pushing the orange hook at the bottom of the RCD upwards. [Small flat screwdriver]

   

7. Put the housing tube back in place, secure the door and add the 2 screws at the bottom of the unit. [Allen 2.5 (hand-tight)]