Version
Revision 1
Used in
- EV One (6522….) / (6531….)
Parts needed
- i1-EN3-1
Tools needed
- Allen 2.5
- Small flat screwdriver
- PH2 screwdriver
Charger Overview
Replacement instructions
-
Remove the 2 screws at the bottom of the housing. [Allen 2.5]
-
Remove the 2 screws holding the door. Place the door in a safe location and remove the housing tube. [Allen 2.5]
-
Remove the top lid and disconnect the MID cable. [Small flat screwdriver]
-
Remove the shielding cover and disconnect the (N / L1 / L2 & L3) cables on the top and bottom of the MID. [PH2 screwdriver]
-
Disconnect the (N / L1 / L2 & L3) cables on the bottom side of the MID (coming from the relay board).
-
A hook at the bottom of the MID is locking the device onto the DIN rail. Pull the hook downwards and remove the MID. [Small flat screwdriver]
-
On the replacement MID, remove the top and bottom lids, then also remove the shielding cover.
-
Put the MID in the correct position over the DIN rail and secure it into place by pushing the bottom hook upwards. [Small flat screwdriver]
-
Reconnect the bottom cables. Make sure to follow the correct cable order, from left to right (Brown - Black - Grey - Blue). Then reinstall the bottom lid and close it. [PH2 Screwdriver - Torque 2.5 N.m]
-
Reconnect the top cables coming from the RCD. Make sure to follow the correct cable order, from left to right (Brown - Black - Grey - Blue). [PH2 Screwdriver - Torque 2.5 N.m]
-
Put the shielding cover back into place. Reconnect the 3 open ends of the MID cable to the MID. Connect the full blue cable to the “B-” port, the blue-white cable to the “A+” port and the orange cable to the “G” port. Note: in case of only 2 wires, connect the full blue cable to the “B-” port and the blue-white cable to the “A+” port. [Small flat screwdriver - Torque 0.3 N.m]
-
Put the top lid back into place and close it.
-
Put the housing tube back in place, secure the door and add the 2 screws at the bottom of the unit. [Allen 2.5 (hand-tight)]