Version
Revision 1
Used in
- EV Base (6020….) / (6021….) / (6023….) / (6030….) / (6031….)
Parts needed
- AC-RCDA-4P40A
Tools needed
- Allen 2.5
- Hex 10
- Hex 19
- PH2 screwdriver
- Small flat screwdriver
Charger Overview
Replacement instructions
Note: while the RCD is mounted horizontally in the unit, the “top” of the RCD refers to the top of the device when it is in a vertical position.
-
Loosen the 6 screws on the back side of the unit. Remove the M6 screw and the anchor nut on each side of the unit. Remove the back plate of the unit and place it aside. [Allen 2.5 Hex 10 Hex 19]
-
Disconnect the cables at the top (left side of the unit) or bottom (right side of the unit) of the RCD. [PH2 screwdriver]
-
An orange hook at the bottom of the RCD is locking the device onto the DIN rail. Pull the hook downwards and remove the RCD. [Small flat screwdriver]
-
Position the replacement RCD and connect the cables at the top in the following order: If on the left side of the unit: Slot N: Blue Slot 6: Brown Slot 4: Black Slot 2: Grey If on the right side of the unit: Slot N: Blue Slot 5: Brown Slot 3: Black Slot 1: Grey [PH2 screwdriver - Torque 2.5 N.m]
-
Install the RCD on the DIN rail and secure it by pushing the bottom hook upwards. [Small flat screwdriver]
-
Place the back plate back on the unit. Tighten the M6 screw and the anchor nut on each side of the unit. Tighten the 6 screws on the back side of the unit. [Hex 10 - Torque 5 N.m Hex 19 - Torque 50 N.m Allen 2.5 - Torque 2.5 N.m]