Version

Revision 1

Used in

• EV One (6521….) / (6522….) / (6531….)

Parts needed

• [EV-PCB-SIGNALBOARD-1] - signal board

Tools needed

• Allen 2.5
• Small flat screwdriver
• Flat screwdriver
• Hex 8

Charger Overview

Replacement instructions

1. Remove the 2 screws at the bottom of the housing. [Allen 2.5]

   

2. Remove the 2 screws holding the door. Place the door in a safe location and remove the housing tube. [Allen 2.5]

   

3. Remove the clear cover on top of the signal board and put it aside.

   

4. Loosen and remove the 4 screws holding the signal board. [Allen 2.5]

   

5. Disconnect the 12P cable from the defective signal board. Connect the 12P cable to the replacement board and put the board into place.

   

6. Secure the replacement signal board in place with the 4 screws. Make sure the signal board is properly positioned: the Smappee house icon should be oriented as shown in the picture. [Allen 2.5]

   

7. Place the clear cover back in position.

   

8. Put the housing tube back in place, secure the door and add the 2 screws at the bottom of the unit. [Allen 2.5 (hand-tight)]

   

   

Replacement instructions App

After physical replacement, you will need to power-cycle the Connect and replace the signal board via the app.

Settings → Charging station → Select module → Replace

How to replace a Charging Station module via the Smappee App