Version
Revision 1
Used in
- EV Base (6020….) / (6021….) / (6030….) / (6031….)
Parts needed
- i1-EN3-1
Tools needed
- Allen 2.5
- Hex 10
- Hex 19
- PH2 screwdriver
- Small flat screwdriver
Charger Overview
Replacement instructions
Note: while the MID is mounted horizontally in the unit, the “top” of the MID refers to the top of the device when it is in a vertical position.
-
Loosen the 6 screws on the back side of the unit. Remove the M6 screw and the anchor nut on each side of the unit. Remove the back plate of the unit and place it aside. [Allen 2.5 Hex 10 Hex 19]
-
Open the bottom lid of the MID and disconnect the cables. [PH2 screwdriver]
-
Remove the top lid and disconnect the open ends of the MID cable. [Small flat screwdriver]
-
Remove the shielding cover and disconnect the (N / L1 / L2 & L3) cables. [PH2 screwdriver]
-
A hook at the bottom of the MID is locking the device onto the DIN rail. Pull the hook downwards and remove the MID. [Small flat screwdriver]
-
On the replacement MID, remove the top and bottom lids, then also remove the shielding cover.
-
Position the replacement MID and connect the top cables coming from the RCD. Make sure to follow the correct cable order, from left to right (Brown - Black - Grey - Blue). [PH2 Screwdriver - Torque 2.5 N.m]
-
Put the shielding cover back into place. Reconnect the 3 open ends of the MID cable to the MID. Connect the full blue cable to the “B-” port, the blue-white cable to the “A+” port and the orange cable to the “G” port. Note: in case of only 2 wires, connect the full blue cable to the “B-” port and the blue-white cable to the “A+” port. [Small flat screwdriver - Torque 0.3 N.m]
-
Put the top lid back into place and close it.
-
Put the MID in the correct position over the DIN rail and secure it into place by pushing the bottom hook upwards. [Small flat screwdriver]
-
Connect the cables going to the relay board. Make sure to follow the correct cable order, from bottom to top (Brown - Black - Grey - Blue). [PH2 Screwdriver - Torque 2.5 N.m]
-
Place the back plate back on the unit. Tighten the M6 screw and the anchor nut on each side of the unit. Tighten the 6 screws on the back side of the unit. [Hex 10 - Torque 5 N.m Hex 19 - Torque 50 N.m Allen 2.5 - Torque 2.5 N.m]