Version

Revision 1

Used in

• EV Wall (6120….) / (6121….) / (6123….) / (6220….) / (6221….) / (6420….) / (6230….) / (6231….)

Parts needed

• [EV-PCB-SIGNALBOARD-1] - signal board

Tools needed

• Hex 7
• Hex 5.5

Charger Overview

Replacement instructions

1. Loosen the 2 nuts at the back of the front plate, remove the front plate and disconnect the cable from the signal board. Pay attention not to damage the connectors. Place the front plate aside. [Hex 7]

   

   

2. Loosen the 4 M3 nuts and remove the signal board. [Hex 5.5]

   

3. Make sure the spacers are still in place and mount the replacement signal board. Make sure the board is correctly oriented: the LEDs on the board must match the housing cutout on the plate (connector on the bottom left of the board).

   

   

4. Secure the signal board into place with the 4 M3 nuts. [Hex 5.5 (hand-tight)]

   

5. Reconnect the signal board, place the front plate back and retighten the 2 nuts. [Hex 7]

   

   

Replacement instructions App

After physical replacement, you will need to power-cycle the Connect and replace the signal board via the app.

Settings → Charging station → Select module → Replace

How to replace a Charging Station module via the Smappee App